| Model |
Chassis |
Symptom |
Problem Description |
Fix |
| F36450 |
ATC113 |
Power Supply |
Shutdown, pulses 3 times |
Replace FP341 |
| F36650 YX01 |
ATC113 |
RGB |
Dead Set, short on the 12-vdc run supply |
replaced FP341 & IU01 on the kine CBA |
| F32444 |
ATC113 |
Video |
No video |
Pulled video module out and reseated it and video returned |
| F36450 |
ATC113 |
Video |
Dead Set |
Replaced Fuse FP341 and Kine drive IU01 |
| F20TF20TX01 AA1 |
ATC113-AA1 |
Power Supply |
Power light on all the time |
solder bridged at JP352 and JP363, removed solder |
| F27443TX01 BA1 |
ATC113-BA1 |
Vertical |
No vertical Sweep |
Resistor pack RF11 replaced |
| F27650TX01 BB1 |
ATC113-BB1 |
Horizontal |
No horizontal drive |
Replaced shorted CV514 |
| F36650YX01 CA1 |
ATC113-CA1 |
Horizontal |
shuts down intermittently |
Glue under TL902 was conducting, removed glue |
| F36450YX01 CA1 |
ATC113-CA1 |
Kine Drive |
No Green |
Replaced leaky DU51 (pin 8 of IU01) |
| F36650YX01 CA1 |
ATC113-CA1 |
Power Supply |
squeels, raster collapses |
bad solder, resoldered CP550 |
| F32650YX01 CA1 |
ATC113-CA1 |
Power Supply |
Dead set |
Fuse FP341 open, replaced fuse. |
| F36650YX01 CA1 |
ATC113-CA1 |
Power Supply |
Dead set |
Replaced FP27 |
| F36650YX01 CA1 |
ATC113-CA1 |
RGB |
Dead set |
Fuse FP341 replaced, IU01 (kine drive) replaced |
| F36450YX01 CA1 |
ATC113-CA1 |
System Control |
Shuts down |
Glue under CR541 was conducting, removed glue |
| F32650YX01 CA1 |
ATC113-CA1 |
Video |
No Video |
Found solder bridge between JL16 and N/17, remove bridge |
| F32444YX01 CA1 |
ATC113-CA1 |
Video |
No Video, retrace lines |
Replace CV515 |
| F32444YX01 CA1 |
ATC113-CA1 |
Power Supply |
Distorted Audio |
Replace DA04 (18V Zener) |
| F20TF20TX01 AA1 |
ATC113-AA1 |
Power Supply |
Squeeling |
CP11 installed wrong value from factory, replace with .0168 1.6kV |
